TM 9-2330-379-14&P
FRONT DOLLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
WARNING
Enough support must be provided for con-
necting link, and upper and lower arm
assemblies to allow pins to be removed from
front adapter without requiring excessive
force or personal injury may occur.
WARNING
After the connecting pins have been driven
out, the pipe or rod used in the process must
be removed in order to remove the desired
components. At this time all components must
be completely supported or suspended or
personal injury may occur.
NOTE
The easiest way to remove the connecting pins
is to drive all of the pins out together
using a long pipe, or rod, starting at either
end. The limited space will not allow the
inside pins to be removed in a different
manner.
5
Front
Lower arm
a.
Remove nut (8) and bolt (7) that
adapter (1)
assembly (3), secure pin (6) attaching lower arm
pin (6), bolt
assembly (3) to front adapter (1).
(7) and nut
b.
Perform same procedure on other
(8) side
of front dolly.
6
Lower arm
a.
Remove nut (11) and bolt (10) that
assembly (3)
secure pin (9) attaching lower arm
upper arm
assembly (3) and upper arm assembly
assembly (2),
(2) to front adapter (1).
pin (9), bolt
b.
Perform same procedure on other side
(10), and nut
of front dolly.
(11)
7
Lower arm
Bonded joint
Remove two end bushings, (14) center
assemblies
(12), center
spacer (13), and bonded joint (12) from
(3)
spacer (13),
each pivot tube on each lower arm
and two end
assemblies (3).
bushings (14)
5-4
