TM 9-2330-275-14&P
2-11. ATTACHING DOLLY SET TO SHELTER (Cont).
(33) For the M840, remove two Iockpins (40) and quick-
release pins (38) from brackets (39) of support struts (22). Aline holes
at ends of support struts (22) with holes in suspension bar (25), and
install two quick-release pins (38) and Iockpins (40).
(34) For the M832, remove two wire lanyards (26) from
around lower pins (27) on support struts (22).
(35) Lower drawbar (6) to lift suspension bar (25),
ensuring that lifting lips (48) remain fully installed in brackets (46) at
bottom of shelter (47).
(36) Rotate release valve lever (17) to PUMP position.
(37) Operate hydraulic pump (18) until upper surface of
each suspension bar (25) rests against shelter (47).
(38) Install two bolts (37) and fully tighten.
2
5
4 7
2-24