TM 9-2330-275-14&P
4-61. SHOCK ABSORBER AND MOUNTING BRACKET REPLACEMENT (Con’t).
5.
Remove bolt (16)or nut (1), lockwasher (2), and upper stud (8) from mounting bracket (3). Discard lockwasher.
6.
Remove three bolts (4), Iockwashers (5), and mounting bracket (3) from dolly. Discard lockwashers.
b.
Installation
NOTE
l Before installing shock absorber, paint circular bands as required per
Appendix G, Figure G-2.
l Perform steps 1 through 3 only if mounting bracket was removed.
1.
Install mounting bracket (3) on dolly with three new Iockwashers (5) and bolts (4).
2.
Install nut (1), new lockwasher (2), and upper stud (8) or bolt (16) on mounting bracket (3).
3.
Install lower stud (14) on bracket (15) with new Iockwasher (2) and nut (1).
NOTE
Position shock absorber with large diameter on top.
4.
Install one washer (6) on lower stud (14) and one washer (6) on upper stud (8) or bolt (16). Install shock
absorber (13), sleeve (9), and four rubber bushings (7) on upper and lower studs (8 and 14) or bolts (16).
5.
Install washer (10), new Iockwasher (11), and nut (12) on lower stud (14).
6.
Install washer (10), new lockwasher (11), and nut (12) on upper stud (8) or bolt (16).
4-158
