TM 10-8340-243-13&P
0014
Replace Detent Assemblies
WARNING
When handling tent frame, do not grasp the frame
near the frame joints. Failure to do so can result in
personnel injury to hands and fingers. Failure to
follow tie down and staking instructions may result in
possible injury to personnel and damage to
equipment.
1. Loosen and remove two worm gear clamps (Figure 3, Item 1) securing detent assembly (Figure 3,
Item 2).
2. Remove detent assembly (Figure 3, Item 2).
CAUTION
Do not overtighten worm gear clamps.
3. Position detent assembly (Figure 3, Item 2), with channels for worm gear clamps (Figure 3, Item 1)
parallel to end of frame member or fitting (Figure 3, Item 3).
detent assembly (Figure 3, Item 2). Ensure that clamps are placed in channels in detent assembly.
5. Alternately tighten worm gear clamps (Figure 3, Item 1) until detent assembly (Figure 3, Item 2) is
securely attached to tube or fitting.
2
3
1
Figure 3. Replace Detent Assembly.
END OF TASK
