TM 10-8340-243-13&P
0005
2. Lay the three frame assemblies on the ground. Put the center wall frame assembly (Figure 3, Item 2)
in between the two end wall frame assemblies (Figure 3, Item 1). Make sure the left hand purlin
3. Unfold the rafter assemblies (Figure 3, Item 4) on each frame assembly away from the center as far
as they will go. Each of the three frame assemblies should form a "V". Do not unfold the legs at this
time.
4. Lock the rafter assemblies (Figure 3, Item 4) into place at the peak fitting (Figure 3, Item 5) by
engaging the teeth and turning the handles (Figure 3, Item 6) on each fitting downwards until they
are tight, and the rafter assemblies (Figure 3, Item 4) cannot move. Repeat this process for each of
the three frame pieces.
5
4
3
5
1
1
4
2
3
4
5
6
