TM 10-8340-227-13&P
2-7. PREPARATION FOR MOVEMENT AND STORAGE - Continued
WARNING
Frame assembly will be under tension when removing pins. Stand to side of frame assembly
poles when performing the next step. Frame members could strike and injure you if they slip.
CAUTION
Do not lean on frame when removing hook and loop fasteners. Damage to frame could result.
To prevent damage to tent fabric, avoid dragging frame assembly over tent.
j. Remove frame assembly from tent body assembly.
k. Remove four frame poles from center hub.
l. Fold frame poles and secure with rubber bands.
m. Insert folded tent frame assembly into its bag. Close drawstring and cinch web straps.
n. Remove tent pegs and store in peg bag.
o. Keeping tent body assembly extended and square, uniformly spread roof, walls, and floor.
p. Grasp corners at front and rear of one side of tent body assembly and fold to centerline. Fold again to
centerline. Repeat for opposite side.
NOTE
Folded width of tent should be approximately same length as stowed frame assembly.
q. Place folded fly, liner, gear loft, and tent pin bag on tent body.
r. Place frame assembly package at end and on top of folded fly and tent body assembly. Roll to form a tight
package, using frame package as a hub.
2-44
