TM 10-8340-227-13&P
2-6. DECALS AND INSTRUCTION PLATES - Continued
grommet on flap and staking opposite ends of rope at 45
degree angles.
INSTALLING TENT FROST LINER
Find top center of liner at point where "D" ring is attached.
Fasten "D" ring to top center snap inside tent, making
sure that the opening in the side of liner is aligned with
stove pipe shield of tent. Fasten snaps inside tent to rings
on outside of liner around eave of tent at eight locations,
starting at either door of tent. Fasten bottom of liner to
bottom of tent at inside corner snap and ring locations.
Secure two tape fasteners at center bottom of each side
wall to complete installation of liner. (No fastener at
doors of tent).
NOTE: Tent may be packed without removing liner.
DO NOT PACK WET LINER.
PACKING THE TENT
1. Take down the tent, reversing pitching procedures.
NOTE: Tent may be packed without removal of liner.
DO NOT PACK WET LINER.
2. Insert folded tent frame into pole bag, close
drawstring, and cinch web straps.
3. Keeping floors extended and square, uniformly spread
roof, walls, and tub within the perimeter.
4. Grasp corners at front and rear of one side of floor and
fold to centerline of floor. Fold again to centerline of
floor. Repeat at opposite side. (See Fig. J).
NOTE: Folded width of tent should be approximately
same length as pole package.
Figure J
5. Grasp fly at each corner, fold in half so that fly is
completely flat. Grasp one extended point of fly and fold
to centerline. Repeat at opposite point. Fold roof to the
center of the fly so that top edge is straight. Fold fly to
the same width as the folded tent. (See Fig. K).
Figure K
Figure 2-1. Instruction Label (Sheet 4 of 5)
2-41
