TM 10-8340-227-13&P2-6. DECALS AND INSTRUCTION PLATES - ContinuedFigure C8. Attach eave rope loops located at each corner of tentto lugs on tent frame. Afterattachingthefirstlooptoitslug,grasp cord on the opposite side of center retainingweb and insert into lug. (See Fig. D). Repeat atremaining corners.Figure D9. Wrap 2" tape fasteners around poles (between eaveand roof). Leave 2"-3" distance between wall of tent andinside of frame. (See Fig. E). Check that door closesproperly after attaching tape fasteners. Loosen ifnecessary.Figure E10. If Yukon or other stove is to be used, open andsecurely roll up flap on right side wall of tent, which willexpose the stove pipe shield. If stove is not to be used,secure flap to tape fastener around shield.CAUTION: A METAL-, SAND-, OR DIRT-FILLED TRAYMUST BE INSTALLED UNDERNEATH STOVE WHENIT IS IN USE.11. (See Fig F). Adjust tension with top and corner ropesand tape fasteners.Figure FFigure 2-1. Instruction Label (Sheet 2 of 5)2-39
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business