ARMY TM 10–8340-224-13
AIR FORCE TO 35E5–6–1
NAVY NAVFAC–P–337.A
5-15. TEST AND REPAIR LIGHT SET, Type I (CONT).
(a) Remove fuse cap and fuse.
(b) Remove molded male (1) and female (2) end caps from
luminaire (3).
(c) Disconnect lampholder (4) by pressing retainer (5).
(d) Pull lens/screen assembly (6) off the extrusion
assembly (7) to expose the ballast (8).
(e) Separate bracket (9) from male end cap (1).
(f) Remove ring terminals (10) from rear of switch (11).
(g) Unscrew switch seal (12) and remove switch (11) and
paper insulation (13) from the rear of the bracket
(9).
(2) Install Switch.
(a) Insert new switch (11)
into cutout in bracket
(b) Screw switch seal (12)
(c) Connect ring terminals
through paper
(9).
onto threaded
insulator (13)
toggle sleeve.
(10) to switch (11).
(d) Install bracket (9) into male end cap (1).
(e) Slide extrusion assembly (7) into lens/screen
assembly (6).
(f) Install lampholders (4).
(g) Install male (1) and female (2) end caps over
luminaire (3).
h.
Remove and Install Fuse Cap and Fuseholder.
(1) Remove Fuseholder.
(a) Remove molded male (1) and female (2) end caps from
luminaire (3).
(b) Disconnect lampholder (4) by pressing retainer (5).
(c) Pull lens/screen assembly (6) off the extrusion
assembly (7) to expose the ballast (8).
5-24
