ARMY TM 10-8340-224–13
AIR FORCE TO 35E5–6–1
NAVY NAVFAC–P–337.A
(a) Remove end cap (1) on female power cord (2) from
luminaire (3).
(b) Remove lampholder (4) by depressing retainer
connector (5).
(c) Cut female power cord (2) wires from lampholder (4)
and pull power cord (2) out of end cap (1).
(2) Install Female Cable Assembly.
(a)
(b)
(c)
(d)
(e)
Insert loose wire end of new female power cord (2)
through end cap (1) so that approximately three
inches of the cord are inside the end cap (1).
Remove outer insulation from power cord (2) on inside
of end cap (1), and approximately 1/2” from
individual wires.
Solder power cord (2) wires to lampholder (4) wires.
Install lampholder (4).
Install end cap (1) onto luminaire (3).
5-21
