(1)
(2)
(3)
(4)
(5)
ARMY TM 10-8340–224-13
AIR FORCE TO 35E5-6-1
NAVY NAVFAC-P-337.A
Sealer may be applied to outside or inside
of fabric assemblies.
Sealer should only be applied to new
stitches, patches, etc., or those areas
that have shown water leakage.
Two light coats of sealant are more
effective than one thick coat. Do not use
excessive amounts of sealer, as this does
not increase effectiveness and will give
the tent a poor appearance.
Do not leave original sealer container
open, as sealer will thicken and become
unusable.
Limit the amount of time
container is open.
Surface to be sealed should be cleaned as thoroughly as
practical and completely dry before applying sealer.
Pour small amount of sealer into a clean container and
immediately reseal the gallon container.
Apply sealer to stitching or repair to
overlapping seam stitching or edges of
Allow first coat to dry to the touch.
Apply second coat as described in step
be sealed,
repair by 1/2”.
(3).
4-9. REPAIR FRAME
This task covers:
INITIAL SETUP
Tools:
Tool Kit, General
Materials/Parts:
Quick Release Pin
SECTIONS.
Remove and Install Quick Release Pin with
Lanyard Assembly
Mechanics (Appendix B, Section III, Item 3)
with Lanyard Assembly (TM 10-8340–224-23P,
Figure 13, Item 5; Figure 14, Item 2)
Screw, Tapping-Thread (TM 10-8340-224-23P, Figure 13, Item 7;
Figure 14, Item 3; Figure 19, Item 5)
4-7
