ARMY TM 10-8340-224-13AIR FORCE TO 35E5-6-1NAVY NAVFAC-P-337.A4-6. GENERAL (CONT)NOTEThis manual cannot list all malfunctions thatmay occur. If a malfunction is either notlisted or cannot be corrected by the prescribedprocedure, notify your supervisor.Table 4-1. Unit TroubleshootingMalfunctionTest or InspectionCorrective Action1. FRAME ASSEMBLIES WILL NOT FIT TOGETHER.Check for missing or bent frame components. Inspect fordamaged fittings.Replace2. TENT LEAKINGany bent or missing frame components.Step 1. Check to make sure that windows are sealed, the stovepipe opening is closed, all weather flaps are sealed,and all hook and pile fasteners are secured.Close stove pipe opening, seal weather flaps andsecure all hook and pile fasteners.Step 2. Check for rips, tears, holes or separating seams inthe roof cap or wall fabric assemblies.Repair any rips, tears, or holes not exceeding 6inches in length as described in paragraph 4-8.Refer more extensive damage to direct supportmaintenance for repair.Section IV. UNIT MAINTENANCE PROCEDURES4-7. GENERAL. This section contains unit maintenance proceduresapplicable to the TEMPER components as authorized by theMaintenance Allocation Chart (MAC), Appendix B, of this manual.The following topics are included as applicable: inspect, adjust,remove, service, repair, and install. Repairs to the tent fabricassemblies will be limited to rips and tears or holes notexceeding 6 inches. Use the tentage repair kit (NSN 8340-00-262-5767) to accomplish the repair. Consult FM 10-16 for specificguidelines of tentage repair. All maintenance procedures in thissection can be performed by one person unless otherwise indicated4-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business