ARMY TM 10-8340-224-13
AIR FORCE TO 35E5-6-1
NAVY NAVFAC-P-337.A
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Subject
Section/Paragraph
Repair Parts, Special Tools; Test Measurement Diagnostic
Equipment (TMDE) and Support Equipment . . . . . . . . . . . . . . . ...I
Common Tools and Equipment . . . . . . . . . . . . . . . . . . . . . . ...5-1
Special Tools, TMDE, and Support Equipment. . . . . . . . . . . . . . .5–2
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..5–3
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...II
Troubleshooting Procedures . . . . . . . . . . . . . . . . . . . . . . . . ..5–4
Maintenance Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . III
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..5–5
Machine Stitching.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...5-6
Automatic Stitching. . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..5–7
Welding . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...5-8
Repair Fabric Assemblies . . . . . . . . . . . . . . . . . . . . . . . . ...5-9
Repair Frame Assemblies . . . . . . . . . . . . . . . . . . . . . . . . ...5-10
Repair Frame Section Components . . . . . . . . . . . . . . . . . . . . . . . . ..5–11
Repair Frame and Power Control Assemblies . . . . . . . . . . . . . . . .5–12
Repair Double Bump-Through Door Assembly. . . . . . . . . . . . . . . . .5–13
Repair Power Control, Type III/IV . . . . . . . . . . . . . . . . . . . . . ...5-14
Test and Repair Light Set, Type I . . . . . . . . . . . . . . . . . . . . ..5–15
Section I. REPAIR PARTS,
SPECIAL TOOLS; TEST MEASUREMENT
DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT
5-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and
equipment refer to the Modified Table of Organization and
Equipment (MTOE) applicable to your unit.
5-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. No special tools
or equipment are required to perform direct support maintenance
on the TEMPER.
5-3. REPAIR PARTS. Repair Parts are listed and illustrated in TM
10-8340-224–23P.
Section II. TROUBLESHOOTING
5-4. TROUBLESHOOTING PROCEDURES. See Tables 3-1 and 4-1 for
operator and unit troubleshooting procedures.
5-1
