6-2
Figure 6-1.
(3) Disengage the roller chain from the
winch sprocket (4) and remove the door winch
shaft assembly from the transom chord.
(4) Remove the spring pins to disassemble
the winch shaft stub (2), left and right winch
shafts (7 and 10), shaft sleeves (3 and 8), and
winch sprocket.
(5) Reassemble the transom chord assemb-
ly in reverse order of disassembly.
c. Cable and Toggle Pin Assembly. Fabricate
a cable and toggle pin assembly from the toggle
pins supplied and 1/8-inch diameter wire rope
cut into 13-foot lengths. Follow the procedure
outlined in paragraph 3-21b.
6-7. Door Spar Assembly, Disassembly and
Reassembly
a. Remove the filler block (4, fig. 6-2) from
the spar (2).
b. Mark the position of, and remove the nut
(3) from the bolt (8) and remove the nut and
flat washer (5).
c. Remove the bolt, nylon roller (7), helical
compression spring (6) and flat washer.
d. Reassemble the floor spar assembly in re-
verse order of disassembly.
