Parts Secured by Spring Pins

Section Ill. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT

TM-10-8340-207-14 Tent. Lightweight Frame-Type Expendable Cotton Duck 12.29 Oz. Per Sq Yd Fire Mildew Water and Weather Resistant Manual
Page Navigation
68

CHAPTER 6 REPAIR INSTRUCTIONS Section I. TENT FABRIC, TENT LINER PIPES, AND WELDING 6-1. Tent Sections, liners, and Covers b. Thread each end of the pipe. For repair instructions on the tent sections, c. Install galvanized end eyes on liners, and covers, refer to TM 10-267, TM 10- 269, and TM 10-633. pipes. 6-2. Tent liner Pipes 6-3. Welding end of the Fabricate liner pipes as follows: All welding or repair of broken welds will be a. Cut 3/8-inch or 1/2-inch aluminum pipe in accomplished with an inert gas shielded are 48-inch or 7-foot Iengths, as applicable. Section 6-4. Parts Secured by Spring Pins u. Use an appropriate pin drive punch and hammer and remove the spring pin and unser- viceable part from the assembly. b. Insert a new part in the proper position and drill each hole using the appropriate sized drill. Take special care to position and drill holes in the new part with such precision as to insure proper fit. c. Replace the spring pins. 6-5. Parts Secured with Drive Screws a. Using a chisel, vise grip pliers, claw ham- mer, or crowbar, pull the drive screws from the assembly and remove the unserviceable part. b. Place the new part in the proper position. Drill a new hole within 1/4-inch of the old hole and secure with new drive screws. 6-6. Door Winch and Transom Chord Assembly a. Hoist Assembly, Disassembly and Reas- semble. (1) Refer to figure 6-1 and remove the six machine screws that secure the hoist cover to welder as described in TM 9-237. II. FRAME the hoist support and remove the hoist assemb- ly cover. (2) Remove the four bolts (1, fig, 6-1) that secure the hoist bracket to the hoist sup- port. Lift the hoist assembly to disengage the roller chain (2) from the winch sprocket, and remove the hoist assembly from the transom chord. (8) Remove the hoist chain (4). (4) Remove the roller chain (2). (5) Reassemble the hoist assembly in re- verse order of disassembly. b. Transom Chord Assembly, Disassembly and Reassembly. (1) Remove the machine screws (1, fig. 3- 32) that attach the gusset plates (2) to the transom chord (3) and remove the gusset plates and gusset plate shim from the transom chord. (2) Remove the nuts and lockwashers (6, fig. 3-31) from the capscrews (5) that attach the nylon bearing brackets (1) to the transom chord. Remove the capescrews and nylon ring brackets from the transom chord. 6-1

Privacy Statement
Press Release
Contact