TM 10-7310-281-13&PMODERN BURNER UNIT (MBU)0019 00OPERATOR SERVICES0019 00-1INSTALL 15FT CROSSWAY CABLETHIS SECTION COVERS:Installation (one time procedure)INITIAL SETUPCable mounting brackets installed by fielding contractorMaintenance LevelMaterials/PartsUnitTools and Special ToolsShop Equipment Automotive Maintenance and Repair:Organizational Maintenance, Common No. 1 (WP 0038, Table 2, Item 2)INSTALLBefore the MBU can be used with the MKT, the Crossway Cable (1) must be installed under the trailer.This is a one time procedure performed when the MBU is initially fielded. Once installed, the CrosswayCable remains in place unless the cable is damaged in some way and requires replacement.The cable clamps (2) that secure the Crossway Cable to the MKT support beam (3) are installed by thefielding contractor and will be in place prior to installing the Crossway Cable.To install the Crossway Cable (1), take position with the required tools under the right, rear end of theMKT in the vicinity of the cooling cabinet which houses the Power Converter Mounting Bracket.Locate the support beam (3) on which the cable clamps (2) are mounted.Distribute the Crossway Cable (1) along the ground under the trailer support beam (3) so that an equalamount of cable is available to pass up through the trailer floor under the cooling cabinet as well asunder the left side between the cabinet and griddle.Approximately 1 to 1-1/2 ft of cable should be available on each end to pass through the trailer floor.Once the cable has been distributed to allow a sufficient amount to pass up through the floor of thetrailer, move to the far left end of the support beam and remove the screw (4) that secures the first cableclamp (5).Place the cable in position on the support beam (3) and reinstall the clamp.Move down the support beam, installing the cable under each clamp, one at a time, until the entire cablehas been installed under all the clamps.While under the cooling cabinet area on the right side of the trailer, remove the rubber grommet (6)mounted in the trailer floor.Cut the grommet and install over the Crossway Cable (1).Push the connector (7) of the Crossway Cable up through the hole in the floor of the trailer and reinstallthe rubber grommet (6).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
