TM 10-5411-201-14
T.O. 35E4-178-1
5-2.
(cont)
6.
Remove four screws (14) and two switch covers (15).
7.
Remove four screws (16), nuts (17), and lockwashers (18), and remove
two light switches (19) from circuit breaker box (5).
8.
Remove circuit breakers (20 through 25) from circuit breaker box
(5) .
9.
Remove grommets (27) from circuit breaker box (5).
CLEANING, INSPECTION
1.
Clean circuit breaker panel and components surfaces:
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for and replace if necessary:
a.
Missing or damaged components
b.
Corrosion or paint damage.
Repair corrosion or paint damage.
(Refer to paragraph 4-44)
REPAIR
ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
8.
9.
Install grommets (27) in circuit breaker box (5).
Install circuit breakers (20 through 25) in circuit breaker box (5).
Connect wires (9) to circuit breakers (20 through 25).
(Refer to
paragraph 4-47)
Position two light switches (19) in circuit breaker box (5) and
secure with four screws (16), nuts (17), and lockwashers (18).
Position two switch covers (15) over light switches (19) and secure
with four screws (14).
Connect wires (9) to light switches (19).
(Refer to paragraph 4-47)
Position panelboard (8) over circuit breakers (20 through 26) in
circuit breaker box (5) and secure with four screws (6) and washers
(7).
Position circuit breaker panel cover (4) against circuit breaker box
(5) and secure by moving four clamp fingers (3) to LOCK position and
tightening four captive screws (2).
Close circuit breaker panel door (l).
5-3
