REPAIR OF PUNCTURE WITH MINIMAL DAMAGE TO CORE

REPAIR OF DEPRESSION OR SMALL PUNCTURE (cont) - TM-10-5411-201-14_248

REPAIR OF PUNCTURE WITH CORE FRACTURE - TM-10-5411-201-14_250

TM-10-5411-201-14 Shelter Tactical Expandable One-Sided NSN 5411-01-124-1377 60 AMP Model NSN 5411-01-295-3433 100 AMP Model Manual
Page Navigation
230

TM 10-5411-201-14 T.O. 35E4-178-1 4-36. (cont) d. Center patch over damaged area and mark patch outline on panel skin. e. Sand all paint from damaged panel skin within marked area, with sandpaper (Item 17, Appendix E). f. Center patch over damaged area and drill No. 30 diameter holes in panel skin. Use holes in patch as a template. g. Index patch and panel skin with a mark to allow patch to be replaced in same orientation. h. Deburr all drill holes. W A R N I N G Methylethylketone is flammable and toxic and shall be used only in a well-ventilated area away from all sparks or open flame. Gloves should be worn during use. i. Wipe damaged area and patch with a clean cloth (Item 5, Appendix E) dampened in solvent (Item 20, Appendix E) and immediately wipe solvent from surfaces with a clean, dry cloth. DO not allow solvent to get into exposed core. j. Mix sufficient amount of adhesive (Item 1, Appendix E) in accordance with manufacturer’s instructions. k. Pack adhesive in puncture and all exposed core cells. Use mixing sticks (Item 21, Appendix E) to pack adhesive and obtain a smooth surface. 1. Apply a thick film of remaining adhesive to mating surface of patch. m. Place patch over prepared area in same orientation used in step f. n. Align holes diameter blind rivets and, using hand blind riveter, install 1/8 in. (3.18 mm) (Items 15-16, Appendix E). (Refer to paragraph 4-33 ) o. Clean repaired surface. p. Caulk around patch. (Refer to paragraph 4-43 ) q. Refinish in accordance with paragraph 4-44. 4-167

Privacy Statement
Press Release
Contact