TM 10-5411-201-14T.O. 35E4-178-14-35.(cont)h.Wipe sanded surface with clean cloth (Item 5, Appendix E) dampenedin solvent (Item 20, Appendix E) and immediately wipe solvent from surfacewith a clean, dry cloth.i.Mask sanded surface with masking tape (Item 22, Appendix E).j.Mix small quantity of adhesive in accordance with manufacturer’sinstructions.k.Using spatula or putty knife, fill damaged area with adhesive.1.Apply external heat source at 200°F (93.3°C) for 40 to 60 minutes tofully cure adhesive.m.Sand surface of cured adhesive to conform to surrounding area.n.Remove masking tape and clean repaired surface.o.Refinish in accordance with paragraph 4-44.4-36.REPAIR OF PUNCTURE WITH MINIMAL DAMAGE TO CORE.NOTEThe following procedure coversin any shelter panel skin with(damaged area not exceeding 14Use hand router to cut patchesrepair of punctureminimal core damage,square in. (90.3 sq cm)).and openings.a.Dry panel per paragraph 4-32, if required.b.Using portable electric router, Appendix B,Item 15, cut aluminum patch (Item 4, Appendix E) oneinch larger all around than damaged area.WARNINGWear safety goggles for eye protection fromflying metal chips.c.Layout and drill holes as shown.4-166
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business