TM 10-5411-200-14
T.O. 35E4-177-1
2-21.
(cont)
c.
Drive each of eight loop and clamp ground anchors into ground
approximately 3 feet (91.5 cm) deep, and as close as possible to the shelter
attaching points,
at locations indicated below.
d.
Set each ground anchor by forming a loop in cable end and secure
loop with clamp.
e.
Insert driving rod through loop and pull
is set into ground.
NOTE
This setting of the anchor is required to turn the
anchor in the ground so that it develops maximum
holding power.
2-35
