FIXED ROOF AREA CEILING LIGHT TESTING, REPLACEMENT, AND REPAIR (cont)

FIXED ROOF AREA CEILING LIGHT TESTING, REPLACEMENT, AND REPAIR (cont) - TM-10-5411-200-14_117

FIXED ROOF AREA CEILING LIGHT TESTING, REPLACEMENT, AND REPAIR (cont) - TM-10-5411-200-14_119

TM-10-5411-200-14
Page Navigation
98

TM 10-5411-200-14 T.O. 35E4-177-1 4-12. (cont) 6. Remove nuts (17) and remove ballast (16) from light frame (3). 7. Drill out rivets (18) and remove two light support plates (19) from light frame (3). (Refer to paragraph 4-32) CLEANING, INSPECTION 1. Clean hinged roof area ceiling light and component surfaces. 2. Inspect mounting surfaces for corrosion and damage. 3. Inspect for and replace if necessary: a. Missing or damaged components. b. Corrosion or paint damage. REPAIR Repair corrosion or paint damage. (Refer to paragraph 4-43) ASSEMBLY 1. Position two light support plates (19) on light frame (3) and install rivets (18). (Refer to paragraph 4-32) 2. Position ballast (16) in light frame (3) and secure with nuts (17). 3. Connect two wires from ballast (16) to contacts on light frame (3) as follows: Yellow to Yellow Yellow to Black 4. Connect four wires light frame (3) as Red to Black Red to Black Blue to White Blue to White from ballast (16) to contacts at opposite end of follows: CHANGE 2 4-35

Privacy Statement
Press Release
Contact