RECEPTACLE OUTLETS TESTING, REPLACEMENT, AND REPAIR (cont)

RECEPTACLE OUTLETS TESTING, REPLACEMENT, AND REPAIR (cont) - TM-10-5411-200-14_122

TM-10-5411-200-14
Page Navigation
103

TM 10-5411-200-14 T.O.35E4-177-1 4-13. (cont) 1. Position cable and receptacle assemblies against walls with power cord facing up and secure junction box assemblies (4) by using screwdriver and tightening two captive screws (3) on each box. 2. Connect wires from cable and receptacle assemblies to circuit breakers CB3, C85, and CB7. (Refer to paragraph 4-46) 3. Secure electrical cords (2) to walls with velcro straps (1). 4-14. WALL SWlTCH REPLACEMENT This task covers: a Removal b. Installation INlTlAL SETUP Standard Tools Personnel General mechanics tool kit Electrician 1. Set all circuit breakers and switches to OFF position. 2. Remove two screws (1) and switch cover (2). 3. Remove two screws (3) and carefully pull wall switch (4) out of switch box (5) as far as it will go. 4. Disconnect wires from wall switch (4). 5 . Remove two screws (6) and lo&washers (7) and remove switch box (5) from wall. 4-40 CHANGE 8

Privacy Statement
Press Release
Contact