TM 10-5410-284-13&PTM 10602A-13&PLIGHTWEIGHT MAINTENANCE ENCLOSURE (LME)0005 00OPERATION UNDER USUAL CONDITIONS0005 00-9WARNINGLIFT 1Lifting the Structure. To raise the LME to its full position, gather and coordinate procedures, thenproceed as follows:To carry the fabric assemblies and raise the frame structure requires12 persons. Serious injuries may result if less than 12 persons attemptthese tasks. All lifts should be done on command, using proper liftingtechniques to prevent injury to personnel.CAUTIONThe structure must be lifted uniformly. Do not twist or turn framecomponents when handling. Damage to equipment may result. Ensureall quick release pins in the lower arch assemblies are disengagedbefore lifting.Keep material clear of hinge joints during lifting. Place personnel outside the structure, two at each arch frame assembly (1) and two available to swingthe lower arch assemblies (2) out. Grasp the purlins (3) near the arch frame assemblies (1) for safety.On command, lift one side of the structure and swing the lower arch assemblies (2) out, locking theminto position with the attached quick release pins (4).Position the inside blackout flap (5) over the door header and attach the hook and pile (6) as shown.Place the five grommets in one vehicle door section over the five carrier hooks in the door header.Repeat for the other vehicle door section. Thread the braided draw cord attached to the inner doorsection through the “D” ring on the underneath side of the door header and down through the “D” ringattached to the inner door section near the personnel door. Repeat at other end of structure.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business