TM 10-5410-230-13
5-8. FRAME ASSEMBLY (TYPE II ONLY).
This task covers: Repair
INITIAL SETUP
Tools:
Tool Kit, Common No 1 (Appendix B, Section III, Item 4)
Riveter, blind, hand (Appendix B, Section III, Item 5)
Materials/Parts:
Pin and lanyard assembly
Sleeve swaging
Rivets (Appendix B, Section III, Item 5)
Equipment Condition:
Frame assembly may be removed from service, but is not required to perform maintenance steps.
a. Replace Pin Assembly.
(1) Remove damaged pin (1) by separating ring end (2), inserting cable loop (3) under ring end (2) and twisting ring
(2) until cable loop (3) is free.
(2) Obtain a new pin assembly (1) and install onto cable loop (3) by separating ring end (2), inserting cable loop (3)
under ring end (2) and twisting ring (2) until loop (3) is captive inside ring.
b. Replace Pin and Lanyard Assembly.
(1) Drill out rivet (1) securing tab (2) to frame (3).
(2) Position new pin and lanyard assembly and rivet tab (2) to frame (3).
5-5/(5-6 blank)
