BOOT WALL ASSEMBLIES.

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
56

TM 10-5410-230-13 5-7. BOOT WALL ASSEMBLIES. This task covers: Repair NOTE This procedure applies to all Boot Wall fabric components. INITIAL SETUP Tools: Tentage Repair Kit (Appendix B, Section III, Item 1) Industrial Sewing Machine (Appendix B, Section III, Item 4) Materials/Parts: Tentage Repair Kit (Appendix B, Section III, Item 1) Equipment Condition: Boot Wall removed (refer to paragraph 2-7, 2-8, or 2-9). The fabric assemblies should be clean and dry. REPAIR a. Fabric. Refer to paragraphs 4-3 and 4-4 for fabric repair instructions. Any fabric component may be patched or sewn provided the repaired assembly provides a suitable degree of climatic protection and light discipline. b. Fastener Tapes. NOTE It is not necessary to replace an entire piece of fastener tape when only a small portion is damaged. The damaged area can be cut out and replaced, leaving a portion of the original piece in place. (1) Carefully remove stitching (1), cut and remove damaged length of fastener tape (2). Ensure edges are cut straight and no jagged edges remain. (2) Measure width and length of damaged fastener tape (hook or pile) (2) to be replaced. (3) Obtain a replacement part, or fabricate one from bulk or serviceable salvage stocks. (4) Position fastener tape (2) and sew approximately 1/8 inch in from each edge. Ensure stitching (1) runs over from existing portion of fastener tape to the newly inserted portion (2). 5-3

Privacy Statement
Press Release
Contact