CHAPTER 5 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
54

TM 10-5410-230-13 CHAPTER 5 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS Subject Page Section I REPAIR PARTS, SPECIAL TOOLS; TEST MEASUREMENT DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT .............................................................. 5-1 5-1 COMMON TOOLS AND EQUIPMENT .............................................................................. 5-1 5-2 SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT ................................................. 5-1 5-3 REPAIR PARTS ................................................................................................................. 5-1 Section II. MAINTENANCE PROCEDURES .......................................................................................... 5-1 5-4 GENERAL ......................................................................................................................... 5-1 5-5 MACHINE STITCHING ...................................................................................................... 5-1 5-6 AUTOMATIC STITCHING ................................................................................................. 5-2 5-7 BOOT WALL ASSEMBLIES ............................................................................................. 5-3 5-8 FRAME ASSEMBLY (TYPE II ONLY) ............................................................................... 5-5 Section I. REPAIR PARTS, SPECIAL TOOLS; TEST MEASUREMENT DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT 5-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE), CTA 50-970, or CTA 8-100, as applicable to your unit. 5-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. No special tools or equipment are required to perform direct support maintenance on the SICPS Boot Walls. 5-3. REPAIR PARTS. Repair parts are listed and illustrated in the repair parts and special tools list TM 10- 5410-230-13P covering unit maintenance for this equipment. Section II. MAINTENANCE PROCEDURES 5-4. GENERAL. This section contains Direct Support maintenance functions applicable to the SICPS Boot Walls as authorized by the Maintenance Allocation Chart (MAC), Appendix B, Section II, of this manual. The following functions are included: repair. Procedures for machine stitching are provided in paragraph 5-5. Direct Support maintenance personnel may also perform all functions allocated to the Unit and Operator levels. Additional guidance for repair of canvas and webbing is provided by FM 10-16. 5-5. MACHINE STITCHING. All stitch types, except bartacking, shall conform to FED-STD 751. Type 301 and 401 stitching requires 5-7 stitches per inch. Bartacking shall be 1/8 inch in width and free of thread breaks and loose stitching. All stitching will be 1/8 inch from edge or spaced 1/8 inch apart, unless otherwise specified. a. Thread Breaks. Thread breaks in stitching shall be overstitched not less than 1 inch at each break on stitch type 301, and not less than 1 1/2 inches at each break at stitch type 401. Thread breaks in type 401 may be overstitched with stitch type 301. Thread breaks noted during inspection must be repaired by overstitching the existing stitching starting from a distance of 1 inch beyond the break. The ends of repair stitching are not required to be backstitched. 5-1

Privacy Statement
Press Release
Contact