TM 10-5410-230-13
5-7. BOOT WALL ASSEMBLIES. (CONT)
c. Webbing and Buckles.
NOTE
It is not necessary to replace an entire piece of webbing when only a small portion is
damaged and webbing does not need to be threaded through a buckle for adjustment.
The damaged area can be cut out and replaced, leaving a portion of the original piece in
place.
(1) Identify the webbing (1) or buckle component (2) that is damaged and obtain a replacement, or fabricate one
from bulk or serviceable salvage stocks. For fixed webbing pieces, add an inch to length of replacement
piece.
(2) Remove unserviceable webbing (1) or buckle (2) from assembly. Undamaged components should be removed
and salvaged wherever possible.
(3) Assemble and sew buckles (2) and webbing (1) as required to form new assemblies.
(4) Position webbing (1) and buckle (2) assemblies on Boot Wall and sew. For fixed webbing pieces (3), overlap
each end by 1/2-inch.
5-4
