TM 10-5410-230-13
2-9. REMOVING TEE S-250E BOOT WALL TYPE IV (CONT).
g. Unfasten belly band strap (1) form dee-ring buckle (2) by lifting tab (3) on driver's side of Boot Wall (4).
h. Separate hook and pile fastener tapes (5) located on driver's side of Boot Wall (4).
i. Remove blackout wall ladder bracket pocket from ladder bracket and remove lower portion of Boot Wall from around
S-250E shelter (6).
j. Disconnect web straps (7) attached to lifting eyes (8) on hood of HMMWV.
k. Close roll-up up door (9) and secure with hook and pile fastener tape.
1. Remove Boot Wall (4) from S-250E shelter (6).
m. Remove Boot Wall (4) from MCPS tent (10) by removing all quick release fasteners (11) and hook and pile
fastener tapes (12). Work from lower sides upward and then inward toward center.
n. Fold Boot Wall with identification label visible and stow.
o. Install ladder onto bracket on rear of S-250E shelter.
NOTE
If MCPS tent is to remain in service, Install wall unit in accordance with TM 10-5410-229-13&P.
2-30
