TM 10-5410-229-13&P
2-9. PREPARATION FOR MOVEMENT. To prepare the MCPS for movement, follow the procedures outlined in
paragraphs a and b below. As time and circumstances allow, perform operator PMCS "After" services. Clean and dry tent
fabric sections and equipment as described in paragraph 3-5. Package the tent into the transport bags as described in
paragraph b below.
a.
Take down procedures. First, locate the three transport bags and the light set storage container, then proceed as
follows:
(1)
Table. Unlock the hinges by pressing the center in towards the table top. Fold the legs of the table in
towards the center and remove from tent.
(2)
Mapboards.
Lift the mapboards (1) off the equipment straps (2) and pull the sections apart by lifting the tab over the
button at the center edge of each mapboard section (1) and sliding the mapboards apart. Remove
mapboards from tent. Remove straps and store in tent pin container.
(3)
Luminaires. Unplug the power source cord from the luminaires. Do not remove the luminaires until the
frame assembly has been lowered. See paragraph (5) (d) below.
2-46