TM 10-5410-229-13&P
2-8. DECALS AND INSTRUCTION PLATES - Cont’d
FIGURE 5: ATTACHMENT OF THE WALLS
1.
STANDING INSIDE THE TENT, LINE UP EITHER A WINDOW WALL OR PLAIN WALL AND BUCKLE THE
WALL TO THE ROOF.
2.
NOW, FASTEN THE VELCRO, WORKING FROM THE CENTER OUT.
3.
NEXT, INSTALL THE OTHER WALLS IN THE SAME WAY, INCLUDING THE ENTRANCE WAY WALL.
4.
OVERLAP THE TENT FABRIC AT THE CORNERS OF ALL FOUR WALLS. FASTEN THE BUCKLES ON THE
INSIDE, AND TIGHTEN THE STRAPS.
5.
REMEMBERING THAT THE POLES STAY INSIDE THE TENT, FASTEN ALL REMAINING BUCKLES, AND
TIGHTEN THE STRAPS.
6.
FASTEN BUCKLES ON THE OUTSIDE OF THE TENT WALLS.
7.
IF NO LINER IS TO BE USED, THEN BUCKLE THE EDGES OF THE FLOOR TO THE WALLS. (3 BUCKLES
PER SIDE).
8.
GO OUTSIDE THE TENT AND PULL THE CORNER FLAPS ON THE ROOF DOWN FLAT. FASTEN THE
VELCRO.
Figure 2-3.
FRAME TRANSPORT BAG
ABBREVIATED MCPS SETUP INSTRUCTIONS - Cont’d
2-41
