TM 10-5410-229-13&P
2-8. DECALS AND INSTRUCTION PLATES - Cont’d
FIGURE 2: PUTTING ON THE ROOF
1.
LIFT THE FOLDED TENT ROOF AND LINE IT UP ALONG THE CENTER PEAK SUPPORT. (SEE DIAGRAM
ABOVE)
2.
UNFOLD ONE HALF OF THE ROOF AND STRETCH IT OVER THE CORNERS OF THE FRAME. REPEAT
FOR OTHER HALF.
3.
FREE THE TENT LINES ON THE ROOF.
4.
PLACE ONE STAKE IN THE GROUND APPROXIMATELY 7 FEET FROM EACH CORNER OF THE TENT AT A
45 ANGLE TO THE TENT. LOOP THE ANCHOR ROPES AT EACH CORNER OVER THE STAKES. LEAVE
THE ROPES LOOSE ENOUGH SO THE TENT CAN BE RAISED. THIS WILL ASSIST IN THE REMAINING
PROCEDURES IN MODERATE TO HIGH WINDS.
Figure 2-3.
FRAME TRANSPORT BAG
ABBREVIATED MCPS SETUP INSTRUCTIONS - Cont’d
2-38
