TM 10-5410-229-13&P2-6.ASSEMBLY AND INSTALLATION INSTRUCTIONS - Cont’d(4)From the outside, lift the flaps on the corner of the roof cap (2) out of the way and flatten the rain gutter flapsagainst the walls of both tents so that the hook and pile fastener strips (4) are aligned, and press themtogether. The rain gutter (1) will extend 10" to 12" out from the MCPS.(5)Pull the flaps on the corners of the roof cap (2) down to seal the small opening where the rain gutter (1)extends from inside the tent.NOTEIf you want the rainwater to run out on one side of the rain gutter, closeoff the end, using the hook and pile fasteners provided. Simply lift theend of the rain gutter up, flatten it out and connect the hook and pilestrips to hold it in place.(6)Fasten the quick disconnect and hook and pile fasteners on the inside and outside corners of the wallassemblies and draw the straps tight.l.EquipmentInstallation.The other components for the MCPS are a light set, four lightweight map boards and twolight-weight tables. The light set has previously been installed (Paragraph 2-6.f.). Once the tent is fully set up, theadditional parts of the MCPS may be carried in through the entrance way.(1)EquipmentStraps.Equipment straps (1) are provided to hang items from the frame. To attach a strap,position the fabric over the top of the frame and push the hook through the loop of fabric. Then hang desireditems from hook.(2)MapBoard.Install the map board as follows:2-33
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
