TM 10-5410-229-13&P
2-6.ASSEMBLY AND INSTALLATION INSTRUCTIONS - Cont’d
(a)
Overlap the tent fabric at the corners of each wall (1) by lining up the corresponding side strips of hook
and pile fastener (2) and pressing together.
NOTE
Strap assemblies always line up with the corresponding strap assembly
on the left.
(b)
Fasten the row of quick disconnect fasteners (3) on the inside corners of each wall. Draw the buckle
straps (4) tight.
(c)
Tighten the Corner Roof Cap guy lines (5).
(d)
Fasten the quick disconnect fasteners on the outside of the wall corners and draw the buckle straps (6)
tight.
(e)
Each corner of the roof cap has flaps (7) that must overlap the corresponding wall juncture. Pull the
outside roof cap corner flaps down and press the hook and pile fasteners (8). Make sure the strips are
pressed tight, so that rainwater will stay out and interior light cannot escape.
2-29
