TM 10-5410-229-13&P
2-6.
ASSEMBLY AND INSTALLATION INSTRUCTIONS - Cont’d
(a)
Unfold the wall assembly (1) stretch it out and position it so that the pile fastener strip (2) faces the hook
fastener strip (3) on the roof cap (4) and the quick release fasteners (5) are on the inside.
(b)
The wall assembly (1) attaches to the inside of the roof cap (4) using quick release fasteners (5) first
and then the hook (3) and pile (2) fastener. Standing inside the tent, line the wall assembly (1) up and
fasten it to the roof cap (4) with the quick release fasteners (5). The order in which you fasten the quick
release fasteners doesn’t matter, as long as they are lined up. Make sure the leg assemblies (6) stay
inside the tent. Take care to keep the hook (3) and pile (2) fasteners apart until quick release fasteners
(5) are fastened.
(c)
From inside the MCPS, starting in the center of the wall assembly (1), line up the pile (2) fastener strip
on the wall assembly (1) with the hook fastener (3) on the roof cap assembly (4) and press them
together. Work from the center toward each end in order to prevent wrinkles in the hook (3) and pile (2)
fastener strips.
(6)
Entrance Way Set-Up. The entrance way provides blackout protection as well as protection from inclement
weather. Set up the entrance way as follows:
2-27
