TM 10-5410-229-13&P2-6. ASSEMBLY AND INSTALLATION INSTRUCTIONS - Cont’d(2)Attach pile fastener located along the top of the liners (4) to hook fastener along the top of the walls (5).Fasten quick disconnect male fasteners (6) to quick disconnect female fasteners (2) along the top of thewall. Attach the liners between the leg assemblies of the frame (7) and the walls (8) (the frame legs will bevisible on the inside of the MCPS after the liner is installed).(3)Fasten the quick disconnect fasteners (9) on buckle assemblies (10) on the inside of the wall corners anddraw the straps tight.(4)The entrance way wall liner door (11) should be opened if entry/exit is desired. Unfasten the quickdisconnect fasteners (12) and hook and pile fastener (13) and roll the door section from one side to theother. Buckle assemblies (14) with quick disconnect fasteners are provided to secure the liner open.j.Floorinstallation.Install the floor, with light colored side up, by simply spreading it out inside the tent. Pull anyextra slack to the edges of the tent so that the walking surface is free of wrinkles. When all walls and liners have beeninstalled, attach the edges of the floor to the walls or liners.k.Raingutterinstallation.If one MCPS is to be connected to another, the tents must be positioned next to oneanother with the corners lined up. They should be spaced three to six inches apart. It does not matter which sides faceone another as long as they are approximately the same height and the corners are lined up. Tents may be joined side toside, end to end, or side to end. When connecting MCPS together, attach the rain gutter as follows:2-31
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
