TM 10-5410-229-13&P
2-8. DECALS AND INSTRUCTION PLATES - Cont’d
FIGURE 4: EXTENDING THE FRAME TO ITS FULL HEIGHT
1.
CHOOSE ONE THE SIDES WITH THREE LEGS.
2.
PLACE ONE PERSON AT EACH CORNER.
3.
LIFT THE FRAME INTO THE AIR AND PULL THE PULL PIN ON THE BASE OF EACH LEG. THEN PULL THE
LEG EXTENSIONS OUT UNTIL THEY LOCK. (INTERMEDIATE HOLES ARE PROVIDED FOR FINAL HEIGHT
ADJUSTMENT.)
4.
DON’T EXTEND THE CENTER LEGS AT THIS TIME.
5.
REPEAT THE PROCEDURE ON OTHER SIDE.
6.
POSITION TENT AT DESIRED LOCATION, EXTEND THE CENTER LEGS.
7.
DRIVE STEEL TENT PINS THROUGH EACH FOOT.
8.
INSTALL THE FLOOR, WHITE SIDE UP, BY SPREADING IT OUT INSIDE THE FRAME.
Figure 2-3.
FRAME TRANSPORT BAG
ABBREVIATED MCPS SETUP INSTRUCTIONS - Cont’d
2-40
