TM 10-5410-229-13&P5-11.REPAIR LIGHT SET- Cont’d1.Remove Female Cable Assembly.(a)Remove end cap (1) on female power cord (2) from luminaire (3).(b)Remove lampholder (4) by depressing retainer connector (5).(c)Cut female power cord (2) wires from lampholder (4) and pull power cord (2) out of end cap (1).2.Install Female Cable Assembly.(a)Insert loose wire end of new female power cord (2) through end cap (1) so that approximately three inches ofthe cord are inside the end cap (1).(b)Remove outer insulation from power cord (2) on inside of end cap (1), and approximately 1/2" from individualwires.(c)Solder power cord (2) wires to lampholder (4) wires.(d)Install lampholder (4).(e)Install end cap (1) onto luminaire (3).d.Remove and Install Male Cable Assembly.5-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
