TM 10-5410-229-13&P
5-11.
REPAIR LIGHT SET - Contd
1.
Remove Male Cable Assembly.
(a)
Pull molded end caps (1) off luminaire (2).
(b)
Disconnect lampholder (3) by depressing retainer connector (4).
(c)
Pull the luminaire (2) off the extrusion assembly (5) to expose the ballast (6).
(d)
Remove splices (7) and disconnect black (8) and white (9) wires of the male power cord (10).
(e)
Disconnect the male power cord ground wire (11) from the ground post (12).
(f)
Pull male power cord (10) out of the molded end cap (1) and bushing (13).
2.
Install Male Cable Assembly.
(a)
Push male power cord (10) through the molded end cap (1) and bushing (13).
(b)
Connect black (8) and white (9) wires of the male power cord (10) and re-install splices (7).
(c)
Connect the male power cord ground wire (11) to the ground post (12).
(d)
Install molded end cap (1) of male power cord (10) over luminaire (2).
(e)
Install lampholder (3), and end cap (1) of female power cord (13) over luminaire (14).
5-14