TM 10-5410-229-13&P
5-11.
REPAIR LIGHT SET - Cont’d
(e)
Remove ring terminals (9) from rear of switch (10).
(f)
Unscrew switch seal (11) and remove switch (10) from the rear of the bracket (8).
2.
Install Switch.
(a)
Insert new switch (10) through paper insulator (12) into cutout in bracket (8).
(b)
Screw switch seal (11) onto threaded toggle sleeve.
(c)
Connect ring terminals (9) to switch (10).
(d)
Install bracket (8) into male end cap (1)
(e)
Slide extrusion assembly (6) into luminaire (3).
(f)
Install lampholders (4).
(g)
Install male (1) and female (2) end caps over luminaire (3).
f.
Remove and Install Fuseholder.
1.
Remove Fuseholder.
(a)
Remove molded male (1) and female (2) end caps from luminaire (3).
(b)
Disconnect lampholder (4) by pressing retainer (5).
(c)
Pull luminaire (3) off the extrusion assembly (6) to expose the ballast (7).
(d)
Remove (cut) insulation from rear of fuseholder (13) and remove wires from fuseholder terminals.
(e)
Unscrew fuseholder cap (14) and remove fuseholder (13) from switch bracket (8).
2.
Install Fuseholder.
(a)
Place new fuseholder (13) into position through switch bracket (8).
5-16
