TM 10-5410-224-14
so that the light can be used at the cargo end of
(2) Swing holding bracket away from the light
the shelter while connected to a utility outlet on
fixture.
the service entrance panel at the personnel end.
(3) Move entire light fixture lengthwise in the
When used in this manner, the cable is routed
direction that allows the fixture to be disengaged
over the top of the shelter. When the light is used
at the personnel door, the excess cable slack
from the four mounting captive fasteners in
should be neatly coiled so that it does not present
ceiling.
a hazard to personnel.
(4) Move fixture into appropriate (left or
(8) Connect exterior light cable connector to
right) shelter section and engage the four captive
one of two utility outlets (J4 or J19) on the power
fasteners in the ceiling.
entrance panel (fig. 3-11). If connected to J4, light
NOTE
can be controlled by circuit breaker CB5 on the
The captive fasteners must be unscrewed to lower
them in order to accommodate the light fixture.
circuit breaker panel. If connected to J19, light can
be controlled by circuit breaker CB7.
(5) After light fixture is properly located,
e. Utility Outlet Installation. Relocate 12 utility
insert captive screw on fixture into threaded insert
outlets from stowage locations (fig. 3-1) to
in ceiling to secure light fixture.
deployed positions in left and right sections of
(6) Repeat steps (1) through (5) for three
shelter (fig. 3-11).
other ceiling light fixtures.
NOTE
NOTE
Normally, either ECU units or ventilation fans are
The removable exterior light is normally attached
installed in the shelter, but not both. If ECU
and used at the personnel end of the shelter.
However, it can also be installed at the cargo end
units are to be used, install the units according to
paragraph f. If ventilation fans are to be used,
of the shelter if necessary.
install according to paragraph g.
(7) Remove the exterior light from its stowage
f. ECU Installation. To install the ECU's,
location on the inside of the cargo door (fig. 3-1)
proceed as follows:
and attach it to the personnel end panel (fig. 3-11)
(1) Pull out four closure plugs (fig. 3-12) from
or the cargo end panel as required.
outside of ECU panel intended for location of ECU
NOTE
installation.
The exterior light is supplied with a 25-foot cable
