TM 10-5410-221-24
Note. Mark or otherwise identify electrical
b. Installation. Install TB5 terminal board (45) in
leads for ease at installation. Refer to tables 6-1 and 6-2
reverse order of removal using figure 6-22 as a guide
and procedures outlined for harness and assemblies
and observing the following.
removal and replacement, chapter 6, sections II, III, and
(1) Position terminal board (45) in distribution
IV.
box and secure with nuts (43) and screws (44).
(3) Remove connector link (32) terminals.
(2) Replace electrical leads on proper
(4) Remove nuts (26) and screws which
terminals and secure with washers (48), lockwashers
secure the terminal board (28) to distribution box.
(47) and nuts (46).
(3) Press cover (42) on terminal board (45).
b. Installation. Install TB4 terminal b in reverse
order of removal using figure as a guide and observing
TB6 Terminal Board
the following.
(1) Position terminal board (28) in distribution
a. Removal. Remove TB6 terminal board (68)
box and secure with nuts (26) and screws (27).
according to sequence of index numbers assigned to
(2) Place connector link (32) over terminals
on terminal board.
(1) Remove cover (65) from terminal board
(3) Replace electrical leads on proper
(68).
terminals and secure with washer (31), washer (30) and
(2) Remove nuts (69), lockwashers (70), and
nut (29).
washers (71), and remove electrical leads from terminals
(4) Press cover (25) over terminal board (28).
1 through 6.
Note. Mark or otherwise identify electrical
6-44.
TB5 Terminal Board
leads for ease at installation. Refer to tables 6-1 and 6-2
a. Removal. Remove TB5 terminal board (45)
and procedures outlined for harness and wire
assemblies removal and replacement, chapter 6,
according to sequence of index number assigned to
sections II, III, and IV.
(3) Remove nuts (66) and screws (67) which
(1) Remove cover (42) from terminal board
secure the terminal board (68) to the distribution box.
(45).
(2) Remove nuts (46), lockwashers (47) and
b. Installation. Install TB6 terminal board (68) in
washers (48), and remove electrical leads from terminals
2 through 10.
reverse order of removal using figure 6-22 as a guide
and observing the following.
Note. Mark or otherwise identify electrical
(1) Position terminal board (68) in distribution
box and secure with nuts (66) and screws (67).
leads for ease at installation. Refer to tables 6-1 6-2 and
(2) Replace electrical leads on proper
procedures outlined for harness and assemblies removal
terminals and secure with washers (71), lockwashers
and replacement, chapter 6, sections II, III, and IV.
(70) and nuts (69).
(3) Remove nuts (43) and screws which
(3) Press cover (65) firmly in place over
secure the terminal board (45) to distribution box.
terminal board (68).
