TM 10-5410-221-24
(2) Remove nut (53), lockwasher- (5and
(2) Replace electrical leads on proper
washer (55). Remove electrical leads from terminals 1
terminals and secure with washer (55), lockwasher (54)
through 5.
and nut (53).
(3) Press terminal board cover (57) on
Note. Mark or otherwise identify electrical leads for
terminal board.
ease at installation.
procedures outlined for harness and wire semblies
6-42.
TB3 Terminal Board
removal and replacement, chapter 6, section II, III and
IV.
a. Removal. Remove TB3 terminal board (38)
(3) Remove nut (50) and screw (5) from
according to sequence of index numbers assigned to
terminal board (52) and remove from distribution box.
(1) Remove cover (35) from terminal board
b. Installation. Install TB1 terminal board (52) in
(38).
and observing the following.
washers (31), and remove electrical leads from terminals
(1) Position terminal board (52) in distribution
1 through 5.
box and secure with nuts (50) and screws (51).
Note. Mark or otherwise identify electrical leads for
(2) Replace electrical leads on prop terminals
ease at installation. Refer to tables 6-1 and 6-2 and
referring to tables 6-1 and 6-2, and sections II, III, and IV
procedures outlined for harness and wire assemblies
for terminal identification and location. Secure leads with
removal and replacement, chapter 6, sections II, Ill, and
wash (55), lockwasher (54) and nut (53).
IV.
(3) Press terminal board cover (49) securely
(3) Remove connector link (32) from
over terminal board.
terminals.
(4) Remove nuts (36) and screws (37) which
secure the terminal board (38) to the distribution box.
6-41.
TB2 Terminal Board
b. Installation, Install TB3 terminal board (38) in
a. Removal. Remove TB2 terminal board (60)
according to sequence of index number assigned to
and observing the following.
(1) Position terminal board (60) in distribution
(1) Remove cover (57) from terminal board
box and secure with nuts (36) and screws (37).
(60).
(2) Place connector link (32) over terminals
(2) Remove nuts (53), lockwashers (54) and
on terminal board.
washers (55), and remove electrical leads from terminals
(3) Replace electrical leads on proper
1 through 5.
Note. Mark or otherwise identify electric leads
terminals and secure with washer (31), lock washer (30)
and nut (29).
for ease at installation. Refer to tables 6-1 and 6-2 and
(4)Press cover (35) on terminal board (38).
procedures outlined for harness and wire assemblies
removal and replacement, chapter 6, section II, III, and
IV.
6-43.
TB4 Terminal Board
(3) Remove nuts (58) and screws (59) which
secure the terminal board (60) to the distribution box.
a. Removal. Remove TB4 terminal board (28)
according to sequence of index numbers assigned to
b. Installation. Install TB2 terminal board (60) in
(1) Remove cover (25) from terminal board
and observing the following (1) Position terminal board
(28).
(60) in distribution box and secure with nuts (5, 8) at
screws (59).
washers (31), and remove electrical leads from terminals
1 through 5.
6-61