Figure 6-10. Fluorescent lights receptacle box assembly

TM 10-5410-221-24

e. Assembly. Assemble light wiring harness (13,

(3)

Install identification strap(2) around wires

(5).

14 fig. 6-1) in reverse order of' disassembly using figure

6-19 as a guide and observing the following.

f. Test. Use a continuity light, multimeter or other

(1) Install insulation sleeving (3) over wires (5)

continuity checking device to check continuity of wiring

and push back to expose connection end. Solder wires

(fig. 6-19). Continuity must exist between end fittings on

(5) to connector (4) according to Specification MIIS872

individual wires. Continuity must not exist between

using Sn60 solder that conforms to Specification QQ-'

connector pins or between connector pins and connector

571.

Slide insulation sleeving (3) over soldered

shell. If continuity does not exist between end fitting on

connection points.

wires replace wire or connector.

Note. Install wires on connector pins accor

g. Installation.

Install male fluorescent light

ing to figure 6-9. If wires are replaced, mark wire 1

harness assemblies in reverse order of removal using

cation number from removed wire onto replacement

figure 6-19 as a guide for terminal identification and

wire.

figure 1-7 for wiring schematic.

(2) Install terminals (1) on wires (5 and crimp to

secure.

Figure 6-10. Fluorescent lights receptacle box assembly.

6-11

Privacy Statement
Press Release
Contact