TM 10-5410-221-24
Figure 6-5. 60 Hertz power out harness assembly.
and connector assembly (7, fig. 6-1) to the output panel
reverse order of disassembly using figure 6-6 as a guide
assembly.
and observing the following.
(4) Pull the surgical and air-lock light harness
(1) Install terminals (1) on wires and crimp to
assembly from the shelter.
secure.
(2) Install terminals (2) on wires and crimp to
b.
Disassembly.
secure.
e. Test. Use a continuity light, multimeter, or
(1) Remove terminals (1, fig. 6-6).
other continuity checking device to check wiring
(2) Remove terminals (2).
c. Repair.
If possible, straighten any be
continuity (fig. 6-6). Continuity must exist between end
fittings on individual wires. Continuity must not exist
connector pins. Inspect wires for abrasions and cuts of
between connector pins or between connector pins and
insulation. Minor cuts and abrasions are acceptable and
connector shell. If test indicates a defective connector or
may be repaired by wrapping with vinyl tape. Replace
wire, replace the harness assembly.
harness assembly if individual wires are cut or otherwise
f.
Installation.
Install harness assembly in
damaged.
reverse order of removal using figure 6-6 as a guide for
Note. Cuts or abrasions of harness assembly may
terminal identification and figure 1-7 for wiring schematic.
be due to sharp edges of electrical raceways,
interference with other components or improper
6-9.
Fluorescent
Lights
Female
Harness
handling. The cause shall be determined and eliminated
Assemblies
before installation of the harness assemblies.
a. General. The fluorescent light female harness
assemblies (11, 12, fig. 6-1) consist
d.
Assembly.
Assemble
harness
assembly
6-6
