TM 10-5410-221-24
8
LH lamp mount channel
13
Lockwasher (2)
18
Lamp power lead (white)
9
RH lamp mount channel
14
Lamp ground lead (green)
19
Terminal board
10
Fluorescent lamp
15
Washer (2)
20
Nut (1)
11
Nut
16
Terminal barrel nut (2)
21
Washer (1)
12
Nut (2)
17
Lamp power lead (black)
22
Figure 2-8-Continued
Section XI. SHELTER ACCESSORIES
grooves in ground anchor (5).
General
(3) Insert shaft of ground anchor in hole in
end of driving rod. Place holder over rod to hold rod.
This section provides instructions for repair and
Use sledge hammer to drive anchor into ground
replacement of those items considered as accessories to
approximately two feet deep with point of ground anchor
the expandable shelter.
The expandable shelter
angled away from shelter in line with the applicable guy
accessories consists of the guy line slips, guy line ropes,
line rope (2) from the air-lock.
(4) Attach guy line rope (2) to cable assembly
air-lock adapter, bellows adapter, , tread plate, shelter
(3) and tighten guy line rope with guy line slip (1).
jack assemblies and cargo tie down components (fig. 2-
Tent Pins
a. Removal. Pull straight out on tent pin (6, fig.
2-34.
Guy Line Slips and Line Ropes
b. Installation. Install tent pin (6, fig. 2-9) through
a. Removal. Remove guy line rope tension on
O-ring on air-lock ground apron with tang on tent pin
slip (1, fig. 2-9) and untie knot in rope (2) to permit rope
pointed away from shelter. Use a sledge hammer to
end to pass through eyes of slip (1).
drive tent pin flush with ground.
b. Installation. Pass end of guy line rope (2)
through eye of slip (1) through tie down ring on air-lock
Air-Lock Chamber
chamber and then through other eye of slip (1). Tie a
suitable knot in rope (2) to prevent end from slipping
Note. Repair holes, tears and other damage to
back through eye. Tighten guy line rope (2) by pulling
downward on slip (1), slip secures the rope position
fabric of air-lock chamber as described in section VII.
a. Removal.
when released.
(1) Remove light assembly from air-lock
chamber as described in paragraph 2-28, a.
Ground Anchors and Cable Assemblies
(2) Disconnect air-lock chamber guy line
ropes (2, 4, fig. 2-9) from cable assemblies (3).
a. Removal. Release tension on guy line rope (2,
Notes. Remove tent pins (6) used to secure
air-lock chamber ground apron.
Remove cable
and loop on one end of cable assembly (3) and pull cable
assembly (3) through slots in installed ground anchor (5).
replacement chamber is not to be installed at the same
Replace hook in end of cable assembly (3) and install
location.
cable clamps to secure.
Note. Ground anchors are expendable items
(3) Open and disengage zipper between air-
lock chamber (8) and chamber adapter.
and are not removed after installation.
(4) Lift upon bow assemblies (3 through 10,
b. Installation.
(1) Use driving rod and holder from inflatable
Shelter Erection Kit.
(2) Install cable assembly (3, fig. 2-9) in
