TM 9-4931-374-13&P
References
Equipment Conditions
Appendix C
2-17
Circuit breaker on power distribution
Appendix D
panel must be in OFF position.
Appendix E
2-17
120/208V cable assembly disconnected at
3-48
Wiring diagram.
shop set.
3-49
Schematic diagram.
WARNING
3-74
Wire table.
The shop set contains voltages which are dangerous if
contacted. Before performing any maintenance on the
Troubleshooting References
electrical installation, be sure the circuit breaker on
3-9
The power supply does not operate.
power distribution panel connected to power source is
3-7
There is no electrical power at outlets.
in OFF position and the 120/208V cable assembly is
3-9 There is no electrical power at work table outlets.
disconnected from the shop set.
INSPECTION
1
FLEXIBLE CONDUIT AND ALL EXTERNAL ELECTRICAL
2
ALL WIRING. With all covers removed, check for loose or broken
COMPONENTS. Visually inspect to ensure proper condition and
connections. Then check with suitable ohmmeter for continuity. For
security of installation.
more detailed circuitry information, refer to wiring diagram (fig. 3-1)
and schematic diagram (fig. 3-2).
3-47
