TM 9-2330-390-14&P
4-124. FUEL FILTER AND STRAINER REPLACEMENT.
This Task Covers:
a.
Removal
b.
Cleaning and Inspection
c.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
Engine starter switch set to OFF position (see
Diesel fuel (Item 17 or Item 18, Appendix F)
paragraph 2-20).
Rags (Item 25, Appendix F)
Dry cleaning solvent (Item 27, Appendix F)
Tools/Test Equipment:
General mechanics tool kit (Item 30, Appendix G)
Compressor unit (Item 4, Appendix G)
General Safety Instructions:
DO NOT perform this procedure near fire, flames, or sparks.
Dry cleaning solvent is flammable and must not be used near an open flame. Use only In a well-ventilated area.
Compressed air used for cleaning purposes should never exceed 30 psi (267 kPa).
Diesel fuel is combustible. DO NOT smoke or allow an open flame near fuel tank. Shut
down engine when adding fuel. Failure to follow this warning will result in serious injury
or death to personnel. If you are burned, immediately seek medical attention.
DO NOT allow dirt or dust to enter fuel tank. Damage to engine will result.
NOTE
A suitable container should be used to catch any draining fuel. Ensure that all spills
are properly cleaned.
1.
Remove cap (2), drain plug (6), and copper gasket (5) from fuel tank (3). Drain fuel into a suitable container.
2.
Remove strainer (1) from fuel tank (3). Install cap (2) on fuel tank.
4-362
