TM 9-2330-390-14&P
4-123. AIR CLEANER MAINTENANCE (Con't).
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvents flash point is 100° F-138° F (38°-59° C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, immediately wash your eyes and seek medical
attention.
Compressed air used for cleaning or drying purposes, or for clearing restrictions,
should never exceed 30 psi (207 kPa). Wear protective clothing (goggles/shield,
gloves, etc.) and use caution to avoid injury to personnel.
1.
Clean air cleaner flange with a rag dipped in dry cleaning solvent to remove all traces of gasket material. Dry
mounting surface thoroughly with compressed air.
2.
Inspect all removed components for damage. Replace damaged components.
1.
Install new gasket (9) and body (1) on air cleaner
flange (8) with two flange bolts (10).
4-360
