TM 9-2330-390-14&P
4-123. AIR CLEANER MAINTENANCE (Con't).
1.
Remove any accumulated sand or dust from
exterior of cover (3).
2.
3.
Remove wingbolt (6) and cover (3) from body (1).
If damaged, remove seal washer (5) and packing
(2) from cover (3).
4.
If damaged, remove label (4) (see para-
graph 4-106).
5.
Remove element (7) from body (1) and discard.
Dry cleaning solvent, P-D-660, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvents flash point is 100° F-136° F (36° C-59° C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, immediately wash your eyes and seek medical
attention.
Compressed air used for cleaning or drying purposes, or for clearing restrictions,
should never exceed 30 psi (207 kPa). Wear protective clothing (goggles/shield,
gloves, etc.) and use caution to avoid injury to personnel.
6.
Clean body (1), cover (3), and wingbolt (6) with a clean rag. Use a rag dipped in dry cleaning solvent to remove
stubborn dirt and grease. Dry thoroughly with compressed air.
4-358
