TM 9-2330-390-14&P
4-247
4-97.
TOOLBOX MOUNTING BRACKETS REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Toolbox removed (see paragraph 4-103).
Tools/Test Equipment:
General mechanic's tool kit (Item 30, Appendix G)
Portable electric drill (Item 8, Appendix G)
Twist drill set (Item 9, Appendix G)
Blind hand riveter (Item 24, Appendix G)
Materials/Parts:
Four rivets
WARNING
Wear eye protection when using electric drill to drill out rivets. Failure to follow this
warning may cause serious eye injury to personnel.
1.
Drill out four rivets (3) from mounting brackets
(1). Discard rivets.
2.
Remove two mounting brackets (1) from bot-
tom beam (2).
Install two mounting brackets (1) on bottom
beam (2) with four new rivets (3).
Follow-on Tasks:
Install toolbox (see paragraph 4-103).
a.
REMOVAL
b.
INSTALLATION